
Most marks on a car look worse than they are, and a few look smaller than they are. Telling a mark in the clear coat from one that reaches the metal decides what to do next. This article covers judging a mark, touching up a chip and recognizing the work that belongs to a body shop.
Clean the area and look closely
Wash and dry the area first, since much of what looks like a scratch turns out to be a smear of paint or rubber from whatever brushed the car. Then look at the mark in different light: from a low angle, in shade and with a flashlight held close to the panel.
Run a fingernail gently across the mark, not along it. If the nail glides over, the mark is probably in the clear coat on top. If it catches, the mark goes deeper, into the color layer or down to the primer or the metal.
- A smear from something else: it wipes or clays off
- The nail glides over: likely in the clear coat
- The nail catches: deeper, into the color or primer
- Bare metal or rust showing: a body shop
Swirls, scuffs and other shallow damage
Light marks in the clear coat, such as fine swirls or a scuff from a bag, can often be softened with a polish, starting with the gentlest method. The paint and protection guide covers how polishing works and how to stay on the cautious side. Every pass takes away a little clear coat, and it does not grow back.
Polish only a cool, clean panel, by hand or by machine, and stop if the mark is not fading. A mark that stays after a gentle try is deeper than it looked. Put protection back on the area afterwards, since polishing strips any wax or sealant.
Stone chips and touch-up paint
Stone chips are small craters that often reach the primer or the metal, and they collect on the hood, the front bumper and below the windshield. Touching one up seals the spot so water and salt cannot get to the metal. It does not make the chip vanish; the aim is protection first and looks second.
Find the car's color code on its paint code sticker, often in a door jamb, under the hood or in the trunk, and the owner's manual says where. Buy touch-up paint in that code rather than picking by eye, since one color name can cover several shades. Clean the chip, fill it in thin layers with a fine brush, and let each layer dry as the label says.
- The color code from the car's own sticker
- A chip cleaned and dried before any paint goes on
- Thin layers that fill the chip, not the panel around it
- Drying time between layers as the label gives it
When a body shop is the answer
Some marks are beyond cleaning and touch-up. A scratch through to bare metal along a panel, rust bubbling under the paint, a dent, a crack in a bumper or paint lifting at an edge all need a body shop to look at them. So does any damage near a sensor, a camera or a light.
Prime Axle repairs nothing, quotes nothing and points to no shop. Ask the body shop to explain in writing what they see and what they would do, and compare more than one if you can. Until then, keep the area clean and dry.
- Bare metal along a panel
- Rust bubbling under the paint
- A dent, a crack or paint lifting at an edge
- Damage near a sensor, a camera or a light
Fewer marks to begin with
Many fine scratches are wash marks. A gritty sponge, a dropped mitt, a dry towel on dusty paint or the brushes in a tunnel wash each leave their own trace. The two-bucket method from the washing guide, a grit guard and plenty of clean towels cut most of them out.
Everyday habits count as well. Set bags and boxes down away from the paint, keep keys and zippers clear of the doors, and lift dust with a soft towel misted with quick detailer rather than a dry cloth. Deal with each chip early, before a winter of salt reaches the metal beneath it.
In short
- Clean the area before you judge a mark
- A nail that catches means a deeper scratch
- Touch up chips in the car's color code, in thin layers
- Bare metal, rust or a dent goes to a body shop
